![]() In this paper, forming characteristics of aluminium alloy AA2014 forged sheet are systematically investigated using numerical simulation, based on elasto-plastic deformation parameters using Finite Element Analysis (FEA) code PAM-STAMP 2G. Although the HTSUS subheadings are provided for convenience and customs purposes, the written description of the scope of this order is dispositive.The aluminium alloy exhibits excellent isotropy in mechanical properties, with good weldability and corrosion/oxidation resistance, and shows limited shallow drawing formability. Further, merchandise that falls within the scope of this order may also be entered into the United States under HTSUS subheadings 76, 76, 76, 76, 76, 76, 76, 76, 76, 76. Where the nominal and actual measurements vary, a product is within the scope if application of either the nominal or actual measurement would place it within the scope based on the definitions set for the above.Ĭommon alloy sheet is currently classifiable under HTSUS subheadings 76, 76, 76, 76, 76, 76, 76, and 76. ![]() ![]() Aluminum can stock is properly classified under Harmonized Tariff Schedule of the United States (HTSUS) subheadings 7606.12. In addition, aluminum can stock has a lubricant applied to the flat surfaces of the can stock to facilitate its movement through machines used in the manufacture of beverage cans. Aluminum can stock is produced to gauges that range from 0.200 mm to 0.292 mm, and has an H–19, H–41, H–48, H–39, or H–391 temper. Subject merchandise includes common alloy sheet that has been further processed in a third country, including but not limited to annealing, tempering, painting, varnishing, trimming, cutting, punching, and/or slitting, or any other processing that would not otherwise remove the merchandise from the scope of this order if performed in the country of manufacture of the common alloy sheet.Įxcluded from the scope of this order is aluminum can stock, which is suitable for use in the manufacture of aluminum beverage cans, lids of such cans, or tabs used to open such cans. Regardless of specification, however, all common alloy sheet meeting the scope description is included in the scope. The use of a proprietary alloy or non-proprietary alloy that is not specifically registered by theĪluminum Association as a discrete 1XXX-, 3XXX-, or 5XXX-series alloy, but that otherwise has a chemistry that is consistent with these designations, does not remove an otherwise in-scope product from the scope.Ĭommon alloy sheet may be made to ASTM specification B209–14 but can also be made to other specifications. With respect to multi-alloy, clad aluminum sheet, common alloy sheet is produced from a 3XXX-series core, to which cladding layers are applied to either one or both sides of the core. With respect to not clad aluminum sheet, common alloy sheet is manufactured from a 1XXX-, 3XXX-, or 5XXX-series alloy as designated by the Aluminum Association. Common alloy sheet within the scope of this order includes both not clad aluminum sheet, as well as multi-alloy, clad aluminum sheet. The merchandise covered by this order is common alloy aluminum sheet, which is a flat-rolled aluminum product having a thickness of 6.3 mm or less, but greater than 0.2 mm, in coils or cut-to-length, regardless of width. Common Alloy Aluminum Sheet from Germany Scope Description
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |